£19.00 inc. vat

£15.83 ex. vat

In Stock

Order within for delivery on Monday, 26th September

Click & Collect Available

HyperX FURY Low Voltage 4GB DDR3L 1866MHz Memory

  • 4GB memory
  • DDR4 1866MHz
  • 1.35V

View full description

QuickFind: 722624

Mfr part code: HX318LC11FB/4

{{#lists}}
  • {{ title }}
  • {{/lists}}

    HyperX FURY Low Voltage 4GB DDR3L 1866MHz Memory Product Description

    HyperX FURY Low Voltage 4GB DDR3L 1866MHz Memory

    HyperX HX316LC10FB/4 is a 512M x 64-bit (4GB) DDR3L-1600 CL10 SDRAM (Synchronous DRAM) 1Rx8, low voltage, memory module, based on eight 512M x 8-bit DDR3 FBGA components. Each module kit supports Intel® Extreme Memory Profiles (Intel XMP) 2.0. This module has been tested to run at DDR3L-1600 at a low latency timing of 10-10-10 at 1.35V.
    Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC standard electrical and mechanical specifications areas follows:


    PnP JEDEC TIMING PARAMETERS:
    JEDEC/PnP:
    DDR3L-1600 CL10-10-10 @1.35V/1.5V 
    DDR3L-1333 CL9-9-9 @1.35V/1.5V   DDR3L-1066 CL7-7-7 @1.35V/1.5V
    XMP Profile #1: DDR3L-1600 CL10-10-10 @1.35V

    FEATURES

    JEDEC standard 1.35V and 1.5V Power Supply
    VDDQ = 1.35V and 1.5V
    800MHz fCK for 1600Mb/sec/pin
    independent internal bank
    Programmable CAS Latency: 11, 10, 9, 8, 7, 6
    Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
    8-bit pre-fetch
    Burst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not  allow seamless read or write [either on the fly using A12 or MRS] Bi-directional Differential Data Strobe
    Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
    On Die Termination using ODT pin
    Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE ≤ 95°C
    Asynchronous Reset
    Height 1.291" (32.80mm) w/heatsink, single sided component
    726074 
    SPECIFICATIONS

    CL(IDD)  10 cycles
    Row Cycle Time (tRCmin) 44.75ns (min.)
    Refresh to Active/Refresh Command Time (tRFCmin)  260ns (min.)
    Row Active Time (tRASmin)  32.125ns (min.)
    Maximum Operating Power TBD W*
    UL Rating  94 V - 0
    Operating Temperature  0oC to +85oC
    Storage Temperature  -55oC to +100oC

    *Power will vary depending on the SDRAM used.

    HyperX FURY Low Voltage 4GB DDR3L 1866MHz Memory Product Reviews

    Technical Specifications

    General

    Capacity 4 GB
    Upgrade Type Generic

    Memory

    Type DRAM
    Technology DDR3L SDRAM
    Form Factor DIMM 240-pin
    Module Height (inch) 1.29
    Speed 1866 MHz ( PC3L-14900 )
    Latency Timings CL11 ( 11-11-11 )
    Data Integrity Check Non-ECC
    Features Single rank, black heatsink, eight banks, On-Die Termination (ODT), Low Voltage, Black PCB, FURY asymmetric heatspreader, Intel Extreme Memory Profiles (XMP 2.0) , unbuffered
    Module Configuration 512 x 64
    Chips Organization 512 x 8
    Voltage 1.35 / 1.5 V
    RAM Performance SPD - 1333 MHz - 1.35 / 1.5 V - CL8 - 8-8-8 ¦ SPD - 1600 MHz - 1.35 / 1.5 V - CL10 - 10-10-10 ¦ SPD - 1866 MHz - 1.35 / 1.5 V - CL11 - 11-11-11 ¦ Intel Extreme Memory Profiles (XMP 2.0) - 1866 MHz - 1.35 / 1.5 V - CL11 - 11-11-11

    Miscellaneous

    Colour Category Black

    Manufacturer Warranty

    Service & Support Limited lifetime warranty ( Russia - 10 years )

    Customer Questions

    HyperX FURY Low Voltage 4GB DDR3L 1866MHz Memory Ask an owner

    HyperX FURY Low Voltage 4GB DDR3L 1866MHz Memory Product Discussion

    Our comments box is a great way for you to view other people's feedback about products on Ebuyer.com, and add your own.

    • This tool is open to everyone.
    • You are responsible for the contents of your comments and any consequences that may arise as a result of them.
    • Comments that contain any of the following will be deleted: terms considered explicit and inappropriate; defamatory, obscene, unlawful, harmful, or offensive.