ZyXEL Prestige 660R-D1 ADSL Modem Router
- - For router advice email
SOLUTIONS@EBUYER.COM
- Router
- Wired
- Designed for small office
- Faster than ever before - Show more details…
QuickFind code: 148034
Manufacturer ID: 91-004-556021B
Customers also browsed
ZyXEL Prestige 660R-D1 ADSL Modem Router Product Description
Please note: networking components such as switches, routers and wireless devices require that speeds & standards be consistent throughout the network to gain optimum performance. To avoid compatibility clashes or for advice, please contact us on solutions@ebuyer.com.
ZyXEL Prestige 660R-D1 ADSL Modem Router Product Reviews
Ebuyer.com customer reviews give you the chance to give your opinion on the latest technology products. See what customers had to say about this product below. To view more reviews or write your own review, use either of the buttons below.
Ace Piece of Kit
operating system:OtherBrought this as it's one of the few DSL modems around that supports PPP half bridging, sending the public IP through to the inside device making life easy for VPNs.
If you already have a firewall/router/AP without a DSL modem built-in then this is the perfect modem to connect it with.
good bit or kit
operating system:LinuxI have this in front of a m0n0wall firewall and it works perfect. The m0n0wall wan is set to dhcp and the adsl modem has been configured as per the below faq from zyxel:
http://www.zyxel.co.uk/web/support_faq_detail.php?faqID=136
Do ZyXEL routers support a mode of operation where the single public IP address is pushed onto a device such as a separate firewall on the LAN?
Solution:
This mode of operation is referred to as half bridge mode and is only supported on the P-660R-D1 router. In this mode the PPP session is terminated on the router but the IP address is pushed back onto the device on the LAN. DHCP is used to issue the IP address to the device on the LAN. The router also uses this public IP address for the default gateway when it offers the DHCP settings.
It applies to both PPPoA and PPPoE modes. PPPoA is commonly used in the UK.
To set up this mode of operation
1) Configure the router in a standard PPPoA setup so that it works to a PC connected on the LAN
2) Turn off NAT
3) Telnet into the router and at the command line enable half bridge mode: "poe bridge switch on"
4) Set the DHCP lease time to a short period, eg 120 seconds: "ip dhcp enif0 server lease 120"
An excellent piece of equipment!
operating system:Not ApplicableI use this modem in full bridge mode on O2's LLU Pro service.
My upstream sync rate went from ~2Mbps to ~2.5Mbps - an unexpected 25% improvement over the O2 supplied router!
Ignore bad reviews elsewhere
operating system:Not ApplicableMy old ADSL router was acting up, with speeds dropping as low as 200kbps every few days. As I had it connected to a gigabit router, I really only needed a simple ADSL router like this. I have it connected to the gigabit router's WAN interface.
Plugged it all in, entered passwords etc, worked first time. Now getting 6.5Mbps - best ever.
I did a lot of research before buying, and there do seem to be a lot of poor reviews elsewhere - I think they're from people who didn't really understand what they were buying. If you have a 'proper' network or are using a cable modem for a router, this is definitely for you. If you have a single computer, this will work fine. If you have multiple computers and don't have another router, it probably isn't for you.
Technical Specification
Manufacturer ID: 91-004-556021B
General | |
|---|---|
| Device Type | Router |
| Enclosure Type | Desktop |
| Connectivity Technology | Wired |
| Data Link Protocol | Ethernet, Fast Ethernet |
| Capacity | Permanent virtual circuits (PVC) : 8 |
| Network / Transport Protocol | TCP/IP, PPTP, UDP/IP, L2TP, ICMP/IP, IPSec, PPPoE, PPPoA, AAL5, ARP |
| Routing Protocol | RIP-1, RIP-2, IGMPv2, IGMP, static IP routing |
| Remote Management Protocol | SNMP, Telnet, HTTP |
| Authentication Method | PAP, CHAP, MS-CHAP |
| Features | DHCP support, NAT support, ARP support, auto-uplink (auto MDI/MDI-X), packet filtering, dynamic DNS server, MAC address filtering, VPN passthrough, Zero Configuration Technology, Multimedia Auto Provisioner (MAP) |
| Compliant Standards | IEEE 802.1D, IEEE 802.1Q, UPnP |
| Status Indicators | Port status, power |
Line Properties | |
| Framing Format | ANSI T1.413 |
Communications | |
| Type | DSL modem |
| Digital Signaling Protocol | ADSL, ADSL2, ADSL2+, READSL |
| Protocols & Specifications | ITU G.994.1 (G.hs), ITU G.992.3 (G.DMT.bis), ITU G.992.5, ITU G.992.1 (G.DMT) Annex A |
| Max Transfer Rate | 24 Mbps |
Expansion / Connectivity | |
| Interfaces | WAN : 1 x ADSL ¦ 1 x 10Base-T/100Base-TX - RJ-45 |
Power | |
| Power Device | Power adapter - external |
Miscellaneous | |
| Width | 11 cm |
| Depth | 10.7 cm |
| Height | 3.5 cm |
| Weight | 161 g |
Environmental Parameters | |
| Min Operating Temperature | 0 °C |
| Max Operating Temperature | 40 °C |
| Humidity Range Operating | 20 - 85% |
ZyXEL Prestige 660R-D1 ADSL Modem Router Product Discussion
Read terms and conditions
- This tool is open to everyone.
- You are responsible for the contents of your comments and any consequences that may arise as a result of them.
- Comments that contain any of the following will be deleted: terms considered explicit and inappropriate; defamatory, obscene, unlawful, harmful, or offensive.
Don't have a facebook account? Post through our own forums instead
Join in with the Ebuyer product discussions today to ask questions, exchange stories and share opinions with other Ebuyer customers who have bought this product.
So far there are 4 replies to the discussion.
Write a question or comment about this product
Where will my message be posted?
Your message will be posted on the discussion page for this product where you can also
view responses and questions from other Ebuyer customers.
887 in stock
- £24.23inc. vat
Need advice?0872 111 22 22
calls cost 10p per minute + network charges
